Table of Contents
Advertisement
BE–88
WARNING:
·
When storing the steering pad assembly temporarily,
be sure to place it with the pad surface facing upward
on a flat place which is not exposed to direct sun rays.
Also the storing place shall be away from water and
rain.
(4) Cut the wires at the squib connector of the steering
pad assembly. Remove the covering of each end of
the two cut wires about 10 mm.
WARNING:
·
Connect the sections each other whose wire coverings
have been removed so that they may be shorted.
(5) Place the steering pad assembly at the center of the
prepared place. At this time, the pad surface should
face upward.
(6) Disconnect the shorted squib wires of the steering pad
assembly. Connect the alligator clip attached to the
end of the prepared 10m-long wire to each squib wire.
(7) Place the prepared 12-V battery for automotive use at
a corner of the place. Bring nearby the shorted ends
of the wires which is extended from the steering pad
assembly.
WARNING:
·
Be sure to give a warning to other persons about a big
noise that will be emitted at the time of the air bag de-
ployment.
(8) Disconnect the wire ends that have been shorted.
Connect one wire to the positive terminal of the bat-
tery; the other wire to the negative terminal of the bat-
tery, thereby deploying the air bag.
NOTE:
·
There is no need for identifying the polarity of the bat-
tery.
GOOD
JBE00312-05153
Cut out
JBE00313-05154
JBE00314-05155
JBE00315-05156
JBE00316-05157
Advertisement
Table of Contents
