Table of Contents
Advertisement
CH–18
ASSEMBLY OF ALTERNATOR
1. Install the rotor in the drive end frame assembly.
2. Installation of rectifier end frame on drive end frame
(1) Place the wave washer on the rear bearing.
(2) Install the rectifier end frame on the drive end frame
with the two bolts and two nuts or four attaching nuts.
CAUTION:
•
Be very careful not to damage the coil cord during the
installation.
3. Installation of rectifier holder, regulator assembly and
brush holder
(1) Attach the rectifier holder to the end frame with the coil
wires passed through the aperture of the rectifier hold-
er.
(2) Wind the coil wires around the installing section of the
rectifier attaching bolt hole.
JCH00060-00052
JCH00061-00053
JCH00000-00054
JCH00062-00055
JCH00063-00056
Advertisement
Table of Contents
