Chassis - Daihatsu 1997 Terios J100 Service Manual

Table of Contents

Advertisement

MA–26

CHASSIS

BRAKE FLUID
CHANGE
WARNING:
·
Do not mix the different kind and manufacture of brake fluid.
Recommended brake fluid:
FMVSS116 DOT3 or SAE J1703
CAUTION:
·
If the brake fluid is spilled inadvertently over the paint finish surface of the vehicle or the resin made
part, immediately wipe off the brake fluid and flush with fresh water.
·
Be sure to follow the draining order of each wheel cylinder. The draining should be performed from
the farthermost wheel cylinder from the brake master cylinder, one by one.
1. Remove the brake bleeder plug cap.
2. Connect the suitable bleeder hose to the bleeder plug.
3. Prepare a suitable container and connect one end of the
bleeder hose in the container.
4. Depress the brake pedal and have a person hold it in a
depressed state.
5. Slacken the bleeder plug to drain the brake fluid by anoth-
er person and tighten the bleeder plug temporarily.
6. Repeat the steps 4 to 5 until the brake fluid in the reservoir
tank becomes zero.
However, at this state be very careful not to suck the air
into the brake line, except cases where draining of the
brake fluid is required.
7. Replenish the new brake fluid into the reservoir tank and
maintain the brake fluid level in the reservoir tank at the
MAX level during the following operation.
8. Drain the old brake fluid or air from each brake line start-
ing from the farthest wheel cylinder from the master cylin-
der one by one following the manner mentioned in the
steps 4 to 5 repeatedly.
9. Tighten the air bleeder plugs to the specified tightening
torque.
Tightening Torque:
10. Ensure that no air exists in the brake line by depressing
the brake pedal firmly.
If air is remaining in the brake line, perform the air bleed-
ing by following the procedure described in the steps 4 to
5 repeatedly, until air will be discharged. Then, tighten the
bleeder plug to the specified tightening torque.
11. Install the brake bleeder plug cap.
6.9 - 9.8 N·m (0.7 - 1.0 kgf-m)
Front
Rear
JMA00072-00000
JMA00073-00056
JMA00074-00057
JMA00075-00058

Advertisement

Table of Contents
loading

Table of Contents