Table of Contents
Advertisement
BR–14
3. Remove the instrument finish lower panel by removing the
two attaching bolts.
4. Remove the clip of the push rod clevis pin.
5. Remove the push rod clevis pin.
6. Loosen the brake booster attaching nuts evenly.
7. Remove the brake booster attaching nuts.
8. Remove the brake booster from the dash panel.
CAUTION:
·
Be very careful not to deform the brake tubes during
the removal of the brake booster.
INSPECTION
1. Inspection of check valve (vacuum hose)
Check that continuity exists from the booster side to the
engine side. Also, check that no continuity exists from the
engine side to the booster side.
If the inspection results are not satisfactory, replace the
vacuum hose.
2. Inspection of booster push rod-to-master cylinder clear-
ance
Check the clearance of the brake booster push rod.
(Refer to the "Brake master cylinder" section.)
INSTALLATION
1. Install the brake booster to the dash panel with a new
brake booster bracket gasket interposed.
2. Install the attaching nuts and tighten them to the specified
tightening torque.
Tightening Torque:
CAUTION:
·
Care must be exercised so that the brake tubes may
not be interfered with the brake pedal during the instal-
lation.
3. Connect the clevis and brake pedal with the clevis pin.
If any difficulty is encountered in installing the clevis pin,
loosen the lock nut of the clevis and adjust the length of
the push rod of the brake booster by turning the brake
booster push rod or clevis.
4. Apply chassis grease to the sliding surface of the compo-
nents.
5. Install a new clip to the clevis pin.
6. Perform the check and adjustment of the brake pedal.
(Refer to the "Brake pedal" section.)
9.8 - 15.7 N·m (1.0 - 1.6 kgf-m)
JBR00045-00039
JBR00046-00040
Engine side
JBR00047-00041
JBR00048-00000
JBR00049-00042
Advertisement
Table of Contents
