Table of Contents
Advertisement
1. Gap adjustment
Engine hood
(1) Loosen the bolts attaching the engine hood to the en-
gine hood hinge and adjust the engine hood alignment
to the specified value mentioned below.
Specified Value:
4.4 ± 1.5 mm
Gap:
Difference Between Right and Left Sides:
Not to exceed 1.5 mm
Lateral Deviation:
(2) Tighten the engine hood attaching bolts properly.
2. Adjustment of difference in height
(1) Loosen the bolts attaching the hood lock to the radia-
tor supports.
(2) Adjust the hood lock attaching position to adjust the
difference in height to the specified value.
At the same time adjust the height of the hood cushion
rubber so that the clearance between the engine hood
and the cushion rubbers may become zero and the
height at the right and left sides may become the
same.
Specified Value of Difference in Height:
Not more than 1.5 mm
ADJUSTMENT OF FRONT DOOR AND REAR
DOOR
1. Gap adjustment
(1) Front door
q Loosen the attaching bolts of the door hinges,
using the following SST.
SST:
09812-00010-000
CAUTION:
·
Never scratch the painted surface of the body during
the operation.
w Perform the adjustment by changing the attaching
position of the front door hinges to the body.
e Tighten the attaching bolts of the door hinge, using
the following SST.
SST:
09812-00010-000
r Adjust the door lock striker, as required.
(2) Rear door
q Loosen the attaching bolts of the door hinge.
w Perform the adjustment by changing the attaching
position of the rear door hinges to the body.
e Tighten the attaching bolts of the door hinge.
r Adjust the door lock striker, as required.
Not to exceed 1.5 mm
BO–3
JBO00003-00002
JBO00004-00003
SST
JBO00005-00004
JBO00006-00005
Advertisement
Table of Contents
