Table of Contents
Advertisement
22. Remove the O-ring by sticking a needle into the O-ring for
the oil strainer which has been installed at the valve body
side.
NOTE:
•
Be very careful not to scratch the valve body when
sticking the needle into the O-ring.
•
Never reuse the removed O-ring.
23. Remove the manual detent spring by removing the two
bolts.
NOTE:
•
Be sure to remove the bolts evenly and uniformity.
•
The numerals in the right illustration indicate the nomi-
nal length of the bolt.
24. Remove the valve body assembly.
NOTE:
•
Be sure to remove the bolts evenly and diagonally.
•
The numerals in the right illustration indicate the nomi-
nal length of the bolt.
25. Remove the compression spring of the B
piston.
26. Lightly hold the arrow-headed section of the accumulator
No. 1 piston.
27. Remove the piston with the accumulator seal No. 1 and
No. 2 rings installed by applying compressed air into the
oil hole (A).
NOTE:
•
Be sure to put on protection goggles since oil may
splash when using compressed air.
28. Remove the accumulator No. 2 piston with the seal No. 1
ring installed and compression spring.
accumulator
1
AT–51
O-ring
Needle
JAT00107-00085
40
12
JAT00108-00086
$0
$0
@0
$0
@0
@0
@0
@0
JAT00109-00087
JAT00110-00088
JAT00111-00089
Advertisement
Table of Contents
