Daihatsu 1997 Terios J100 Service Manual page 556

Camber, Caster and Kingpin angle
Specified Value
Camber
Caster
Kingpin angle
NOTE:
·
No adjustment can be made for the camber, caster and
kingpin angle. Therefore, if the camber, caster or king-
pin angle fails to meet the specified value, check that
no damage or deformation exists on the frame or cor-
rect the frame, as required.
Toe-in, Turning radius
Specified Value:
Toe-in
Turning Radius In
NOTE:
·
If the toe-in or turning radius fails to meet the specified
value, perform the adjustment, following the procedure
given below, so that both the toe-in and turning radius
may conform to the specified values.
Adjustment of Toe-in and Turning radius
1. Loosen the lock nuts of the tie-rod ends.
2. Perform the toe-in and turning radius adjustment by turn-
ing the tie-rod ends.
CAUTION:
·
When adjusting the toe-in, the tie-rods at the right and
left sides should be turned by the same amount.
·
Make the length (a) indicated in the illustration equal
between the right and left sides. If the length differs be-
tween the right and left sides, a difference occurs in the
wheel turning angle between the right and left sides.
3. Tighten the lock nut.
Tightening Torque:
0°30¢ ± 45¢
2°35¢ ± 1°
13°45¢ ± 1°
0 ± 1.5 mm
+1°20¢
38°28¢
–2°40¢
+1°30¢
Out 33°24¢
–2°30¢
59.8 - 89.2 N·m (6.1 - 9.1 kgf-m)
FS–3
JFS00005-00004
Front
B
A
JFS00006-00005
Front
JFS00000-00006
(a)
JFS00007-00007