Table of Contents
Advertisement
EM–50
(3) Turn the oil seal slightly by hand to see if it can be
turned.
NOTE:
•
Never rotate the oil seal more than one turn, because
excessive turning may cause scratches on the oil seal.
•
If the oil seal can not be turned by hand, it means that
the oil seal has been tilted, driven diagonally or press-
fitted improperly.
•
Do not reuse any oil seal which was tilted or driven di-
agonally.
4. Apply oil to the valve stem. Install the valve to the cylinder
head.
NOTE:
•
Care must be exercised as to the installing position. Do
not pull out the valve once it has been inserted.
•
If the inserted valve should be pulled out, replace the
valve stem oil seal with a new one.
Reference:
Identification of Valves
Engine
HC-EJ
5. Assembly of valve springs, valve spring retainers and
valve spring retainer locks
(1) Assemble the valve spring in such a way that the
painted side (the side having a larger pitch) comes at
the valve spring retainer.
(2) Install the valve spring retainer to the valve spring.
Install the valve spring retainer locks while compress-
ing the valve spring retainer, using the following SST.
SST:
09202-87002-000
Identification No.
r
JEM00201-00185
JEM00202-00186
JEM00203-00187
SST
JEM00204-00188
Advertisement
Table of Contents
