Daihatsu 1997 Terios J100 Service Manual page 729

SR–34
30. Install the tie rod ends to the steering rack ends according
to the mating marks that were put during the removal, ex-
cept for the installation of a new part.
Tighten the nut to the specified torque.
Tightening Torque:
NOTE:
·
Make sure that the tie rod end is installed in the correct
direction.
INSTALLATION
1. Attach the power steering gear assembly to the front sus-
pension cross member sub-assembly from the right.
(On left-hand drive vehicles, attach the power steering
gear assembly from the left side.)
Tightening Torque:
2. Install the bracket retaining the pressure feed hose and re-
turn tube.
Tightening Torque:
3. Attach the tie-rod end to the steering knuckle and tighten
the nut.
Tightening Torque:
4. Install the clip.
5. Install the engine undercover.
6. Install the front wheel.
7. Jack down the vehicle.
8. Connect the return tube and pressure feed hose at the
union section of the steering gear assembly.
Tightening Torque:
9. Connect the intermediate shaft between the steering col-
umn shaft and the steering gear pinion.
Tightening Torque:
NOTE:
·
Make sure that the non-spline section of the steering
column shaft is aligned with the opening section of the
universal joint of the intermediate shaft during the as-
sembly.
59.8 - 89.2 N·m
(6.1 - 9.1 kgf-m)
53.9 - 81.4 N·m (5.5 - 8.3 kgf-m)
4.4 - 10.3 N·m (0.45 - 1.05 kgf-m)
39.2 - 53.9 N·m
(4.0 - 5.5 kgf-m)
39.2 - 49.0 N·m (4.0 - 5.0 kgf-m)
24.5 - 34.3 N·m (2.5 - 3.5 kgf-m)
Mating mark
JSR00128-00122
JSR00129-00123
JSR00130-00124
JSR00131-00125
JSR00132-00126