Table of Contents
Advertisement
DISASSEMBLY
1. Unlock the shaft snap ring of the front door window handle
assembly by inserting a piece of cloth between the handle
and the door vent window control handle plate. Then, pull
the inserted cloth alternately so as to unlock the shaft
snap ring.
2. Remove the front door window handle, shaft snap ring and
door vent window control handle plate.
3. Remove the front door inside handle subassembly attach-
ing screw.
4. Remove the front door pull handle by removing the attach-
ing screw.
5. Unscrew the front door locking button.
6. Unlock the inside door handle from the front door and in-
sert it into the front door trim panel assembly.
7. Remove the front door lower frame bracket garnish by
pulling it out to disengage the retainers provided on the
bracket, using a clip remover.
8. Unlock the nail section of the front door inside handle sub-
assembly from the front door panel and insert it into the
front trim panel assembly.
9. Disengage the retainers provided on the rear side of the
front door trim panel assembly by pulling out one by one
from the door panel.
CAUTION:
·
Be sure to disconnect the retainers, using a clip re-
mover.
Failure to observe this caution may bend the front door
trim panel assembly or cause cracks on the front door
trim panel assembly.
10. Pull up the front trim panel assembly to disengage it from
the front door panel.
11. Disconnect the connector of the wire harness from the
power window switch. (Only for power window-equipped
model.)
12. Remove the front door trim panel assembly from the front
door panel.
BO–45
JBO00111-00093
JBO00112-00094
JBO00113-00095
JBO00114-00096
JBO00115-00097
Advertisement
Table of Contents
