Table of Contents
Advertisement
BE–102
5. Ensure that the diagnosis code No.81 has been erased
and that the normal code is being outputted. Remove the
check lamp and jump wire from the diagnosis connector.
REPLACEMENT AND INSTALLATION OF ANTENNA COIL
1. Disconnect the battery ground cable from the negative (–)
terminal of the battery.
2. Remove the instrument lower finish panel and steering col-
umn lower cover by loosening the attaching screws.
3. Loosen the steering column attaching bolts.
4. Remove the steering column upper cover.
5. Disconnect the connector of the antenna coil and remove
the wire band.
6. Removal of antenna coil.
(1) Loosen the antenna coil attaching screw.
(2) Remove the antenna coil from the ignition key cylinder.
7
Attach a new antenna coil to the ignition key cylinder and
tighten the attaching screw.
8. Attach a new wire band.
9. Connect the connector of the antenna coil.
10. Install the steering column upper cover.
11. Tighten the steering column attaching bolts and nuts.
Tightening Torque:
Nut, lower side 9.8 - 15.7 N·m
Bolt, upper side 14.7 - 21.6 N·m
12. Install the steering column lower cover and instrument
lower finish panel with attaching screws.
13. Connect the battery ground cable to the negative (–) ter-
minal of the battery.
JBE00355-06035
IG "OFF"
JBE00356-06036
JBE00357-06037
JBE00358-06038
JBE00359-06039
Advertisement
Table of Contents
