Table of Contents
Advertisement
13. Installation of transmission brake band assembly-related
parts
(1) Install the compression spring to the second brake
piston assembly.
(2) Install the 2nd brake piston assembly to the transmis-
sion case together with the compression spring.
(3) While compressing the 2nd brake piston with the fol-
lowing SSTs, install the hole snap ring, using snap ring
pliers.
SSTs:
09202-87002-000 ... (A)
09202-87202-0A0 ... (B)
(4) Install a new brake band adjusting anchor bolt to the
transmission.
NOTE:
•
Be sure to tighten the anchor bolt, until the head sec-
tion of the anchor bolt appears at the inside of the
transmission case, as indicated in the right figure.
(5) With the brake band assembly contracted, assemble
the band while aligning its recessed section with the
head of the brake band anchor bolt and with the head
of the 2nd coast brake piston rod.
NOTE:
•
Before assembling the brake band assembly, soak it in
the ATF for at least two hours.
14. Assembly of forward clutch hub and 2nd brake drum
(1) Measure the bush bore diameter of the rear planetary
sun gear subassembly.
Specified Value:
Allowable limit:
NOTE:
•
The measurement should be performed at several
points. Determine the mean value.
•
If the bore diameter exceeds the allowable limit, re-
place the rear planetary sun gear subassembly.
•
When replacing the rear planetary sun gear subassem-
bly, be sure to check the bush contacting surface of the
intermediate shaft subassembly. If the contacting sur-
face is scored or discolored, replace the intermediate
shaft subassembly, too, with a new one at the same
time.
15.500 - 15.518 mm
15.568 mm
AT–73
SST(B)
SST(A)
JAT00199-00174
JAT00200-00175
JAT00201-00176
JAT00202-00177
Advertisement
Table of Contents
