Daihatsu 1997 Terios J100 Service Manual page 818

BO–80
2. Affix the spacers in position as shown in the figure below.
3. Affix the dam in position as shown in the figure below.
4. Apply the primer for the window frame and/or window to under the adhesive agent applying portion if
the adhesive agent has been removed completely.
NOTE:
·
Do not apply the primer when adhesive materials remain on the window frame or window glass. Be
sure to apply the adhesive agent three minutes after the primer has been applied.
5. Apply the adhesive agent to the positions shown in the figure below.
Apply the adhesive agent in such a way that the cross section of the applied agent may measure 8 mm
in its base length and 12 mm in height.
6. Affix the weatherstrip to the upper edge of the back door glass as shown in the figure below.
5
Dam
Back door inner
Cross-section A - A
(On vehicles without rear spoiler)
Back door glass
Back door outer
Cross-section B-B
7. Install the glass by inserting the clips into the holes on the
back door side. Push the entire glass surface lightly so
that the glass may fit completely.
8. Cure the adhesive agent completely.
NOTE:
·
Observe the curing time of the adhesive agent speci-
fied by its manufacturer.
CAUTION:
·
Do not move the vehicle until the adhesive agent of the
window cures completely.
Spacer
Back door outer
Back door glass
8
A
A
*
*
* B
Weatherstrip
Back door inner
Cross-section A - A
(On vehicles with rear spoiler)
Dam application procedure
(From edge of glass)
*
*
*
*
B
*
*
Back door glass
Back door outer
(From edge of glass)
*
Unit: mm
JBO00212-00180
JBO00213-00181