Daihatsu 1997 Terios J100 Service Manual page 681

BR–78
(3) Ensure that the tips of the speed sensors are free from damage or contamination with foreign mate-
rials.
Clean the tips of the speed sensors, if they are contaminated.
(4) Connect the connector of the rear speed sensor to the connector of the wire harness.
5. Removal of speed sensor
NOTE:
·
Refer to the illustration shown in page BR–77.
(1) Turn off the ignition switch.
(2) Disconnect the connector of the speed sensor from the connector of the wire harness.
(3) Disconnect the sensor harness clamp by removing the attaching bolts.
(4) Disconnect the sensor harness clamp form the floor panel by retracting its lock sections, using a
minor screwdriver or the like.
(5) Remove the speed sensor by removing the attaching bolt.
6. Installation of speed sensor
(1) Clean the attaching surface of the speed sensor and backing plate.
(2) Install the speed sensor with the attaching bolt and tightening it to the specified tightening torque.
Tightening torque:
(3) Connect the sensor harness clamp to the floor panel and ensure that the locking section is properly
engaged by pulling it lightly.
(4) Connect the sensor harness clamp with the attaching bolts and tighten them to the specified tight-
ening torque.
Tightening torque:
(5) Connect the connector of the speed sensor to the connector to the wire harness.
(6) Check the speed sensor by performing the sensor check function of the ABS.
6.9 - 9.8 N·m (0.7 - 1.0 kgf-m)
6.9 - 9.8 N·m (0.7 - 1.0 kgf-m)
JABS00098-00000