Table of Contents
Advertisement
BO–26
Vehicles not equipped with roof end spoiler
q Roof rack subassembly (front side)
w Roof rear rack subassembly
e Roof rack assembly
Vehicles equipped with roof end spoiler
q Roof rear rack subassembly
w Rear spoiler subassembly
e Roof rack assembly
4. Remove the roof lining.
(Refer to the trim & garnish section.)
5. Remove the six bolts attaching the rear spoiler and roof rear rack. (Model equipped with rear spoiler.)
6. Disconnect the retainer on the rear spoiler from the roof panel. (Model equipped with rear spoiler.)
7. Gradually lift up the rear spoiler. Then disconnect the connector of the wire harness from the connector
of the high mount stop lamp. (Model equipped with high mount stop lamp.)
8. Remove the rear spoiler with the roof rear racks from the roof panel. (Model equipped with rear spoiler.)
9. Remove the roof rack assembly at each side by removing the three of the five attaching nuts of the roof
rack assembly.
10. Remove the roof rear rack from the rear spoiler subassembly by removing the attaching nuts. (Model
equipped with rear spoiler.)
NOTE:
•
Do not damage the harness of the high mount stop lamp during the removal.
11. Remove the high mount stop lamp from the rear spoiler by removing the attaching screws. (Model
equipped with rear spoiler and high mount stop lamp.)
12. Separate the roof rack from roof rear rack. (Model equipped with roof rack without rear spoiler.)
13. Remove the clips from the rear spoiler subassembly. (Model equipped with rear spoiler.)
e
q
q
e
7.1 ± 1.1 (0.7 ± 0.1)
: Tightening torque
w
Unit : N·m (kgf-m)
7.1 ± 1.1 (0.7 ± 0.1)
w
JBO00000-00058
JBO00065-00000
Advertisement
Table of Contents
