Table of Contents
Advertisement
BO–74
QUARTER WINDOW GLASS
COMPONENTS
REMOVAL
1. Preparation prior to removal
(1) Remove the roof side inner garnish.
(Refer to the trim & garnish section.)
(2) Protection for paint surface around windows
Protect the paint surface around the windows by ap-
plying a protective tape or the like.
CAUTION:
·
To protect the paint surface, be sure to apply a protec-
tive tape to the inside of the edge (groove around the
window attaching surface) as far as it will go.
·
Be sure to protect both cabin and outside surface.
2. Cut off the window glass adhesive by a cutter knife or the
like to make a small hole, in order to pass a piano wire
through the hole.
CAUTION:
·
Be very careful not to damage the paint surface and
window by the cutter knife or the like.
NOTE:
·
Change the position of the hole to be made if any diffi-
culty is encountered, because spacers or retainers are
installed at some parts.
·
For quicker operation, make a hole on the adhesive
agent with a heated wire.
CAUTION:
·
Be very careful not to get scalded during the operation.
e
w
r
e
r
q
q Quarter window glass
w Quarter window glass molding
e Quarter window glass clip
r Quarter window glass spacer
: Non-reusable parts
JBO00195-00166
Protective
tape
JBO00196-00167
Advertisement
Table of Contents
