Table of Contents
Advertisement
2. MAIN POINTS OF INSTALLATION
(1) Tighten the floor shift assembly with the attaching
bolts.
Tightening Torque:
NOTE:
·
Be certain to tighten the attaching bolts in the se-
quence specified in the right figure.
(2) Install the shift cable assembly and select cable as-
sembly in the floor shift assembly. Secure them by
means of the clips.
NOTE:
·
Make sure that the clips are inserted in the correction
direction as indicated in the figure. Never insert them
reversely.
·
Never allow a hammer, etc. to tap the cable during the
clip installation.
·
Insert the clips until they become flush with the lower
edges of the cable retaining surface.
·
Install the clips after the eye end has been installed
first.
14.7 - 21.6 N·m (1.5 - 2.2 kgf-m)
Front
r
e
w
q
MT–49
JMT00150-00133
JMT00151-00134
Advertisement
Table of Contents
