Table of Contents
Advertisement
ASSEMBLY
Front axle hub
Install the hub bolt to the front axle hub by tapping it with suit-
able hammer.
Steering knuckle
1. Installation of disc brake dust cover
Press the disc brake dust cover until it comes in contact
with the steering knuckle, using the following SSTs in com-
bination with the hydraulic press.
SSTs:
09506-87302-000
09718-87702-000
CAUTION:
·
Ensure that the disc brake dust cover is press-fitted to
the steering knuckle positively by ensuring the dust
cover properly contacts with the steering knuckle.
·
Be sure to assemble the brake dust cover to steering
knuckle in such position, as indicated in the figure.
2. Installation of front axle bearing
(1) Press a new bearing into the steering knuckle, using
the following SSTs in combination with hydraulic press.
SSTs:
09310-87302-000
09506-87302-000
(2) Install a new hole snap ring, using snap ring pliers.
CAUTION:
·
Never reuse the used snap ring.
13¡ ± 0.5¡
FS–9
JFS00027-00027
SST
SST
JFS00028-00028
JFS00029-00029
JFS00030-00030
Advertisement
Table of Contents
