Table of Contents
Advertisement
CH–6
Removal of battery
WARNING:
•
Never touch the battery terminals immediately after the
engine stopped.
•
Be certain to turn OFF the ignition switch.
•
Never allow any fire to be brought near the battery.
CAUTION:
•
Be very careful not to drop the battery or apply strong
vibration to the battery.
1. Ensure that the ignition switch is turned OFF.
2. Disconnect the battery ground cable from the negative
terminal of the battery.
3. Disconnect the positive cable terminal from the positive
terminal of the battery.
4. Remove the battery hold-down clamp.
5. Remove the battery.
CLEANING AND INSPECTION OF BATTERY
1. Remove any rust from the battery terminals by means of a
wire brush, a fine abrasive paper, or sodium water and a
soft brush.
NOTE:
•
After the battery terminals have been cleaned, make
sure that no rust particle remains on the terminals.
2. Using adhesive tape or the like, seal the vent hole of each
cell plug.
3. Flush the battery with clean water, using a soft brush.
4. Wipe off the battery surface using a cloth dampened with
clean water.
5. Dry the battery case surface.
Terminals
JCH00015-00000
Hold down
clamp
JCH00016-00009
JCH00017-00000
JCH00018-00010
JCH00019-00011
Advertisement
Table of Contents
