Daihatsu 1997 Terios J100 Service Manual page 693

Table of Contents

Advertisement

BR–90
Replacement of ABS ECU
(Refer to the illustration in page BR–86.)
1. Disconnect the negative terminal of the ground cable from the negative terminal of the battery.
CAUTION:
·
Be sure to read out the diagnosis code of the ABS and EFI systems before disconnecting the battery
power supply.
2. Remove the glove compartment box by removing its retainer. (Refer to BO section.)
3. Disconnect the connector of the wire harness from the ABS ECU.
4. Disconnect the wire harness clamp from the ABS ECU bracket by retracting the mushroom section of
the clamp.
5. Remove the ABS ECU by removing the two attaching bolts.
6. Install the ABS ECU with two attaching bolts.
7. Connect the wire harness clamp to the ABS ECU connector.
8. Connect the connectors of the wire harness to the ABS ECU.
9. Install the glove compartment box by installing its retainer. (Refer to BO section.)
10. Connect the negative terminal of the ground cable to the negative terminal of the battery.
INSPECTION DIODE
1. Remove the check diode from the connector of the wire
harness.
2. Ensure that continuity exists between the terminals of the
inspection diode. Also, ensure that no continuity exists be-
tween the terminals when the attaching order of the tester
probes is reversed, using an ohmmeter. (Refer to the
BR–38.)
Replace the inspection diode if it fails to meet the specifi-
cation.
NOTE:
·
The current flow direction of the ohmmeter differs, de-
pending on its design.
3. Install the inspection diode to the connector of the wire
harness.
STOP LAMP SWITCH
Check the stop lamp switch function.
(Refer to the BE section for inspection.)
JABS00129-00000
JABS00130-00066
JABS00131-00000
JABS00132-00000

Advertisement

Table of Contents
loading

Table of Contents