Table of Contents
Advertisement
3. Adjust the parking brake control handle travel to the spec-
ified number of notches by turning the adjusting nut of the
parking brake pull rod.
Specified Value:
CAUTION:
·
Be sure to use a hexagon socket (box) wrench for ad-
justment to prevent the adjusting nut from being dam-
aged.
4. Install the rear console box with the two attaching screws.
REMOVAL
1. Remove the rear console box by removing the two attach-
ing screws. (Refer to the BO section.)
2. Remove the adjusting nut from the parking brake pull rod.
3. Disconnect the connector from the parking brake switch.
4. Remove the parking brake control handle by removing the
two attaching bolts.
5. Remove the parking brake pull rod by disconnecting the
parking brake cables from the parking brake pull rod.
6. Lift up the vehicle and support the vehicle with safety
stands.
(Refer to the GI section for supporting section of the safety
stands.)
7. Disconnect the parking brake cable assembly from the
brake backing plate.
(Refer to the rear brake section.)
8. Remove the parking brake cable by removing the attach-
ing bolts of the parking brake cable and its clamps.
9. Remove the clamps from the parking brake cable assem-
bly.
5 - 7 notches
BR–31
JBR00100-00084
JBR00101-00085
JBR00102-00086
JBR00103-00000
Advertisement
Table of Contents
