Table of Contents
Advertisement
CONFIRMATION OF LENGTH/SHAPE OF SHIFT FORK
AND SHIFT FORK SHAFT
9. The following three shift fork shafts differ in the overall
length, as shown in the right figure.
NOTE:
·
Be very careful not to make any wrong installation of
these shift fork shafts.
(1)
(2)
(3)
10. The shift forks and shift heads differ in the external view,
as shown in the right figure. Hence, be very careful not to
make any wrong installation of these shift forks and shift
heads.
(1) 1st & 2nd
(2) 3rd & 4th
(3) 5th & Reverse
NOTE:
·
It is advisable to install the shift fork shaft and fork tem-
porarily and confirm that the combination and direction
are right. Then, proceed to the operation.
INSTALLATION TO SHIFT FORK AND SHIFT FORK SHAFT
·
Apply gear oil to the required points. Perform the opera-
tions, following the procedure given below.
11. Temporarily drive a new slotted spring pin into all of the
shift forks and heads so that the slotted spring pin may be
driven easily during installation.
Shift fork shafts
Overall Length
1st & 2nd
3rd & 4th
5th & Reverse
Unit: mm
224.00
259.00
265.00
MT–39
JMT00115-00098
JMT00116-00099
JMT00117-00100
Advertisement
Table of Contents
