Table of Contents
Advertisement
CH–16
Bearings
1. Inspection of front bearing
Ensure that the bearing turns smoothly.
Replace the bearing, if necessary.
2. Replacement of bearing
(1) Remove the four screws and retainer plate.
(2) Remove the front bearing from the drive end frame,
using a suitable socket wrench in conjunction with a
press.
CAUTION:
•
Be very careful not to damage the coil and stud bolts
during bearing removal.
(3) Press a new front bearing into the drive end frame,
using a suitable socket wrench in conjunction with a
press.
CAUTION:
•
Be sure to hold the outer race of the new bearing dur-
ing installation. Holding of the inner race or side cover
will cause bearing damage.
(4) Attach the retainer plate to the drive end frame with the
four screws.
JCH00051-00042
JCH00052-00043
JCH00053-00044
JCH00054-00045
JCH00055-00046
Advertisement
Table of Contents
