Table of Contents
Advertisement
(3) Connect the coil wires to the rectifier holder with the at-
taching screws.
(4) Install the rectifier holder and regulator assembly with
the attaching screws.
NOTE:
•
Make sure that the regulator assembly is installed
properly with the attaching screws as it works.
(5) Install the brush holder in such a way that a gap of at
least 1 mm is provided between the brush holder and
the regulator assembly.
Secure the brush holder with the two screws.
4. Installation of rear end cover
(1) Install the rear end cover on the alternator.
(2) Secure the rear end cover with the three attaching nuts
or screws.
(3) Install the terminal insulator.
(4) Secure the terminal insulator attaching nut.
5. Attach the pulley to the rotor shaft.
Rear end
cover
CH–19
JCH00064-00057
JCH00065-00058
JCH00066-00000
Nut
Terminal
insulator
JCH00067-00059
JCH00068-00060
Advertisement
Table of Contents
