Table of Contents
Advertisement
CO–12
2. Remove the gasket material from the water pump, using a
gasket scraper.
3. Install a new gasket to the cylinder block.
4. Install the water pump to the cylinder block. Tighten the
attaching bolts and nuts evenly over two or three stages to
the specified torque.
Tightening Torque:
14.7 - 21.6 N·m (1.5 - 2.2 kgf-m)
NOTE:
•
After tightening bolts, ensure that the water pump ro-
tates smoothly by hand.
5. Install the timing belt.
(Refer to the EM section.)
6. Fill coolant.
(See page CO–9.)
7. Install the engine under cover.
8. Connect the battery ground cable to the negative (–) ter-
minal of the battery.
JCO00035-00025
JCO00036-00026
JCO00037-00027
JCO00038-00028
JCO00039-00029
Advertisement
Table of Contents
