Daihatsu 1997 Terios J100 Service Manual page 779

INSPECTION
1. Ensure that the seat belt will not be locked until the seat
belt retractor is tilted more than 15 degrees in all direc-
tions from the installed angle.
Also, ensure that the locked state is retained when the re-
tractor is tilted 45 degrees or more.
2. Ensure that the seat belt will be locked when the seat belt
is pulled out quickly.
3. Ensure that no scratch, wear or any other damage exists
on the seat belts.
If any damage is found, replace the seat belt with a new
one.
CAUTION:
·
Never attempt to disassemble the retractor.
·
After the anchor bolts have been tightened, make sure
that each anchor can move in a circumferential direc-
tion of the bolt.
·
Ensure that the belt in the installed state can be pulled
out smoothly and also it can be retracted smoothly in
position.
INSTALLATION
1. Installation of inner seat belt
(1) Install the inner seat belt with the attaching bolt and tighten the attaching bolt to the specified tight-
ening torque.
Tightening Torque:
(2) Install the front seat. (Refer to the front seat section.)
2. Install the front seat retractor with the attaching screw.
3. Install the front seat retractor attaching bolt and tighten the attaching bolt to the specified tightening
torque.
Tightening Torque:
4. Install the seat belt anchor with the attaching bolts and tighten the attaching bolts to the specified tight-
ening torque.
Tightening Torque:
CAUTION:
·
Be sure to install the seat belt end anchor while aligning it with the locating embossed mark on the
floor panel.
5. Install the front seat belt guide with the attaching screws.
6. Close the upper seat belt anchor bolt cover.
7. Install the center pillar lower garnish. (Refer to the trim & garnish section.)
40.5 ± 12.5 N·m (4.1 ± 1.3 kgf-m)
40.5 ± 12.5 N·m (4.1 ± 1.3 kgf-m)
40.5 ± 12.5 N·m (4.1 ± 1.3 kgf-m)
BO–41
45¡
JBO00104-00089
JBO00105-00000