Table of Contents
Advertisement
EM–100
(2) Lubricate the surface of each bearing with engine oil.
NOTE:
•
Do not touch with the front and back surfaces of each
bearing.
•
Never apply engine oil to the crankshaft bearing caps.
(3) Install the crankshaft in the cylinder block.
(4) Apply engine oil to the thrust washers. With the side
having the oil groove facing toward the crankshaft
side, insert each thrust washer between the crankshaft
main journal No. 3 and the cylinder block.
(5) Apply engine oil to the crankshaft main journal sec-
tions.
NOTE:
•
Care must be exercised to ensure that no oil flows into
the bearing cap attaching bolt holes.
(6) Install the crankshaft bearing caps with the arrow
marks facing toward the oil pump side and also in the
numerical sequence.
(7) Thinly apply engine oil to the crankshaft bearing cap
bolts. Tighten the bolts to the specified torque over two
or three stages in the sequence shown in the right fig-
ure.
Tightening Torque:
44.1 - 53.9 N·m
u
e
q
i
r
w
JEM00422-00379
JEM00423-00380
JEM00424-00381
JEM00425-00382
t
o
y
! 0
JEM00426-00383
Advertisement
Table of Contents
