Daihatsu 1997 Terios J100 Service Manual page 762

BO–24
ROOF DRIP MOLDING
COMPONENTS
REMOVAL
1. Remove the rear combination lamp.
2. Removal of roof drip molding
Pull up the roof drip molding from the rear side gradually.
Then remove the molding by pulling it backward to disen-
gage the retainer on the molding from the pin on the roof
panel.
NOTE:
·
Do not reuse the removed roof drip molding.
INSTALLATION
NOTE:
·
Do not reuse the removed roof drip molding.
1. Connect the retainer on the roof drip molding to the pin on the roof panel and insert the front end of the
roof drip molding into the weatherstrip of the front windshield glass.
2. Insert the roof drip molding by push it to the groove on the roof panel.
3. Install the rear combination lamp assembly.
q
w
q Roof drip side finish right molding
w Roof drip side finish left molding
Retainer
Pin
JBO00059-00053
JBO00060-00054
JBO00061-00000