Daihatsu 1997 Terios J100 Service Manual page 651

BR–48
1. Erasing procedure by brake pedal
(1) Connect the following SST to the diagnosis connector.
SST: 09991-87401-000
(2) Connect the ECUT and GND terminals in the SST ter-
minal with the following SST.
SST: 09991-87403-000
CAUTION:
•
Never connect the terminals other than that specified,
for even slight contact of other terminals may lead to
serius malfunction or damage.
(3) Turn ON the ignition switch.(Never start the engine.)
(4) Depress the brake pedal more than 8 times within 5
seconds.
(5) Ensure that the normal code is indicated by the ABS
warning lamp.
(6) Turn off the ignition switch.
(7) Remove the SST (jump wire) from the SST(sub har-
ness).
(8) Turn on the ignition switch.
(9) Ensure that the ABS warning lamp remains extin-
guished after a lapse of three seconds.
If the ABS warning lamp remains illuminated, repeat
the operation above again.
(10) Turn off the ignition switch.
(11) Remove the SST from the diagnosis connector.
2. Erasing diagnosis codes by utilizing the ABST terminal
(1) Connect the following SST to the diagnosis connector.
SST: 09991-87401-000
(2) Turn ON the ignition switch.(Never start the engine.)
(3) Repeat the connection and disconnection of ABST
and GND terminals in the SST four times within eight
seconds, using the following SST.
SST: 09991-87403-000
CAUTION:
•
Never connect the terminals other than that specified,
for even slight contact of other terminals may lead to
serius malfunction or damage.
(4) Ensure that the ABS warning lamp remains extin-
guished.
If the ABS warning lamp remains illuminated, repeat
the operation above again.
(5) Turn off the ignition switch.
(6) Remove the SST (sub harness) from the diagnosis
connector.
ECUT
Ground
JABS00017-00011
Five seconds
Eight times
JABS00018-00012
ABST
E
JABS00019-00013
O/D O/D
OFF OFF
JABS00020-00014