Table of Contents
Advertisement
EM–110
16. Installation of water pump
(1) Install a new water pump gasket on the cylinder block.
(2) Install and tighten the water pump to the specified
torque.
Tightening Torque:
NOTE:
•
When the stud bolts have been replaced, apply the
Three Bond 1377B to the threaded portion at the cylin-
der block side.
17. Attach the tension spring to the timing belt tensioner.
Hang the tension spring hook on the pin. Assemble the
timing belt tensioner in place and install the bolt. Push the
tensioner to the alternator side as far as it will go. Tighten
the tensioner temporarily.
18. Install the crankshaft pulley flange in such a way that its
recessed side may come at the cylinder block side.
19. Install the crankshaft timing belt pulley.
14.7 - 21.6 N·m
JEM00468-00421
JEM00469-00422
JEM00470-00423
JEM00471-00424
JEM00472-00425
Advertisement
Table of Contents
