Table of Contents
Advertisement
EF–16
17. Remove the fuel pump relay. Then, connect the terminal
with a jump wire as indicated in the illustration.
18. Turn the ignition switch to the "ON" position for 10 sec-
onds. Then, turn off the ignition switch.
19. Measure the amount of fuel collected in the measuring
cylinder.
Specified Amount of Fuel:
NOTE:
•
Check to see if the fuel lines and filter exhibit leakage,
deformation or choking.
20. Remove the fuel pressure regulator from the fuel delivery
pipe. Then, install a fuel pressure gauge between the
pressure regulator and the fuel pipe from the fuel filter as
shown in the illustration.
SST:
09268-87701-000
09283-87703-000
21. Turn the ignition switch to the "ON" position.
22. Check to see if the fuel pressure conforms to the specified
pressure.
Specified Value:
NOTE:
•
If the fuel pressure is less than the specification, check
the fuel pump and fuel pressure regulator.
230 ml or more
284 ± 5 kPa
SST (09268-87701)
Hose bands
Hose bands
SST (09283-87703)
To fuel filter
Pressure regulator
To fuel return pipe
Relay
terminal
JEF00052-00342
JEF00053-00343
Hose band
JEF00054-00344
JEF00055-00345
Advertisement
Table of Contents
