Table of Contents
Advertisement
MT–14
REMOVAL OF TRANSFER ASSEMBLY
NOTE:
·
For disassembly of the transfer assembly, refer to
Section TR.
1. Remove the seven bolts indicated in the right figure.
NOTE:
·
The numeral in the right figure denotes the nominal
length of each bolt. (Unit: mm)
2. Top the rib section of the transfer case. Then, pull out it to-
ward you.
3. Remove the extension housing gasket.
NOTE:
·
Never reuse the removed gasket.
4. Remove the needle roller bearing at the forward end of the
transmission output shaft.
DISASSEMBLY
DISASSEMBLY OF SHIFT AND SELECT LEVER RELATED
PARTS
NOTE:
·
After the sifting feeling and continuity for the reverse
backup lamp switch have been checked.
1. Remove the clutch-related parts.
(Detach the engagement of the spring (A).)
2. Remove the control shaft cover with gasket {(A) bolts are
used for the reamer bolt}.
3. Remove the compression spring and ball of the reverse
restrict pin holder (B) with the gasket.
NOTE:
·
Disassemble the control shaft cover, as required.
·
Prior to the disassembly, drive out the grooved pin of
the shift lever shaft.
4. Remove the hexagon bolt (C) of the reverse idler gear
shaft with the gasket.
NOTE:
·
This hexagon bolt is for securing the reverse idle shaft.
Hence, be sure to remove this bolt before the transmis-
sion is disassembled.
40
40
40
JMT00023-00016
210
40
210
JMT00024-00017
(A)
JMT00025-00018
(A)
(A)
(B)
(C)
JMT00026-00019
40
Advertisement
Table of Contents
