Table of Contents
Advertisement
60. Removal of planetary output shaft subassembly
(1) Tap the planetary output shaft subassembly lightly,
using a plastic hammer, until the planetary output shaft
subassembly becomes free.
(2) Remove the planetary output shaft subassembly from
the transmission case side.
(3) Remove the hole snap ring, using snap ring pliers.
(4) Remove the radial ball bearing.
NOTE:
•
If any difficulty is encountered in removing the radial
ball bearing, remove it by applying a light impact from
the inside of the transmission case, using a suitable
brass bar in combination with a plastic hammer.
61. Disassembling of first & reverse brake piston
(1) Temporarily install the removed B2 inspection plug to
the transmission case.
(2) Assemble the following SSTs and set them to the trans-
mission case to remove the first & reverse brake return
spring.
SSTs:
09351-87201-000
09351-87707-000
09351-87709-000
09351-87710-000
NOTE:
•
To prevent the first & reverse brake return spring seat
from being deformed, be sure to stop pressing when
the first & reverse brake return spring seat has been
lowered 1 to 2 mm from the shaft snap ring installation
position.
(3) Remove the shaft snap ring, using snap ring pliers.
NOTE:
•
Be very careful not to deform the shaft snap ring by
spreading it excessively.
(4) Remove the first & reverse brake return spring.
AT–59
JAT00145-00123
JAT00146-00124
JAT00147-00125
JAT00148-00126
JAT00149-00127
Advertisement
Table of Contents
