Table of Contents
Advertisement
EF–46
SYSTEM INSPECTION
VSV No. 1
1. Connect the SST between the EFI ECU connector and the
wire harness connectors. See page EF–18.
2. With the engine running, measure the voltage between the
terminals 60 and 62 of the SST.
Condition
Until engine is warmed up fully after engine starting
1
from engine cold state.
Defogger switch is turned on.
2
Heater blower switch is turned on.
3
4
Headlamp switch is turned on.
NOTE:
•
The measurement should not be performed when plur-
al conditions of those discribed above one met concur-
rently.
•
If the check results will not conform to the requirements
given in the table, check and repair those related sys-
tems.
VSV No. 2
1. Connect the SST between the EFI ECU connector and the
wire harness connectors. See page EF–18.
2. With the engine running, measure the voltage between the
terminals 59 and 62 of the SST.
Condition
Until engine is warmed up fully after engine starting
1
from engine cold state.
The shift lever has been moved from D, 2, L
2
or R to P or N.
Defogger switch, heater blower switch and
3
headlamp switch have been turned on.
NOTE:
•
This VSV is equipped on A/T vehicles only.
•
If the check results will not conform to the requirements
given in the table, check and repair those related sys-
tems.
VSV No. 3
1. Connect the SST between the EFI ECU connector and the
wire harness connectors. See page EF–18.
2. With the engine running and air conditioner switch turned
on, measure the voltage between the terminals 58 and 62
of the SST.
Specified Value:
NOTE:
•
This VSV is used for the air conditioner system.
•
If the check results will not conform to the requirements
given in the table, check and repair those related sys-
tems.
0.5 V or less
Specified value
0.5 V or less
Specified value
0.5 V or less
JEF00132-00941
No. 1
No. 2
JEF00133-00942
JEF00134-00943
JEF00135-00944
JEF00136-00945
Advertisement
Table of Contents
