Table of Contents
Advertisement
EM–112
23. Installation of oil pressure switch
(1) Clean the threaded portion of the oil pressure switch.
Wind seal tape around the threaded portion.
NOTE:
•
The new oil pressure switch is coated with sealer.
Hence, when the oil pressure switch is replaced with a
new one, first remove the sealer thoroughly. Then wind
the seal tape. Also, be sure to clean the threaded holes
at the oil pump side.
(2) Tighten the oil pressure switch to the specified torque
using a long box wrench having a hexagonal hole.
Tightening Torque:
PREPARATION OF ENGINE INSTALLATION
1. Place the cylinder block on a suitable engine stand.
2. Clean and make dry the cylinder head bolt holes.
WARNING:
•
When you use compressed air, be sure to protect your
eyes, wearing goggles.
2. Align the drilled mark of the crankshaft timing belt pulley
with the indicator of the oil pump.
3. Place the new cylinder head gasket on the cylinder block.
11.8 - 19.6 N·m
Identification mark
JEM00478-00431
JEM00479-00432
JEM00480-00433
JEM00481-00434
JEM00482-00435
Advertisement
Table of Contents
