Table of Contents
Advertisement
FS–2
WHEEL ALIGNMENT
PREPARATION
Prior checks
1. Inspect the wear of tires.
2. Inspect the air pressure of the tires.
NOTE:
·
Perform the check on a level floor.
·
Make sure that the same maker's tires having the
same size are mounted.
·
Keep the vehicle in an unloaded state. "Unloaded
state" denotes a condition where the fuel tank is full, a
spare tire is mounted, standard tools and a jack are
mounted at correct storage locations.
Tire Size:
205/70R15 95S
Pressure:
180 kPa (1.8 kgf/cm
3. Inspect the runout of tires.
Maximum Limit:
NOTE:
·
The measurement should be conducted within five min-
utes after the vehicle has been run for at least 30 min-
utes at a speed of 60 to 80 km/h.
4. Ensure that the no looseness are exists on the bolts and
nuts on the related parts of the front axle and steering link-
age.
5. Check of related sections of the front axle and steering
linkage for excessive play
(1) Jack up the vehicle and support it with safety stands.
(Refer to GI section.)
(2) Ensure that no excessive play are exists on the con-
necting sections of the each front axle and steering
linkage by rocking the tire alternately in-and-out or
push and pull while holding the upper and lower parts
of the tire.
2
)
2 mm in a right-and-left direction
1.4 mm in an up-and-down direction
JFS00002-00001
JFS00003-00002
JFS00004-00003
Advertisement
Table of Contents
