Table of Contents
Advertisement
BR–82
y Disconnect the negative terminal of the ground
cable from the negative terminal of the battery.
NOTE:
•
Be sure to read out the diagnosis code of the EFI sys-
tem before disconnecting the power supply to the vehi-
cle.
u Disconnect the connector of the wire harness con-
nected to the ABS ECU.
i Connect the following SST to the connector of the
wire harness disconnected from the ABS ECU.
SST:
09842-87401-000
NOTE:
•
Never connect the connector of the SST to the ABS
ECU.
o Connect the negative terminal of the ground cable
to the negative terminal of the battery.
(2) Inspection of left side front wheel
CAUTION:
•
Never connect the terminal to other terminals than that
specified. Failure to observe this caution may lead to
serius trouble including fire.
q Connect the terminals No. 1 and 2 to terminal No. 19.
w Connect the terminals No. 4 and 5 to terminals
No. 40.
e Connect the terminals No. 3 to terminals No. 18.
r Ensure that the front side left wheel will be locked
when the brake pedal is depressed.
t Ensure that the locked state of the front side left
wheel will be released and the wheel turns freely,
also, ensure that the brake pedal will rise up slight-
ly when the ignition switch is turned ON while de-
pressing the brake pedal.
CAUTION:
•
Never leave the ignition switch in the ON state for 15
seconds or more.
•
Failure to observe this caution will make the actuator
inoperative.
y Turn off the ignition switch immediately after the in-
spection.
If the actuator is not functioning as specified
above, replace the actuator with a new one.
LABS000108-00056
q w e r t
!8
!9
$0
LABS00109-00057
LABS00110-00058
LABS00111-00059
Advertisement
Table of Contents
