Daihatsu 1997 Terios J100 Service Manual page 814

BO–76
2. Affix the quater window glass molding to the quater window with a two-faced tape.
3. Affix the spacers in position as shown in the figure below.
4. Apply the primer for the window frame or window to under the adhesive agent applying portion if the
adhesive agent has been removed completely.
NOTE:
·
Do not apply the primer when adhesive materials remain on the window frame or window glass. Be
sure to apply the adhesive agent three minutes after the primer has been applied.
5. Apply the adhesive agent to the positions shown in the figure below.
Apply the adhesive agent in such a way that the cross section of the applied agent may measure 8 mm
in its base length and 12 mm in height.
F - F cross-section
7
6. Install the glass by inserting the clips into the holes on the body side. Push the entire glass surface
lightly so that the glass may fit completely.
7. Cure the adhesive agent completely.
NOTE:
·
Observe the curing time of the adhesive agent specified by its manufacturer.
CAUTION:
·
Do not move the vehicle until the adhesive agent of the window cures completely.
8. Install the roof side inner garnish. (Refer to the trim & garnish section of the service manual.)
9. Ensure that no water leakage exists.
If any water leakage is found, repair it, as required, or refit the quarter window glass.
Spacer
A - A cross-section
B
A
B
A
F
F
Spacer (Affix it in parallel
with side outer.)
Spacer
E - E cross-section
C
C
120
E
D
E D
Panel Flange
Clip
D - D cross-section
B - B cross-section
C - C cross-section
Unit: mm
JBO00201-00172
JBO00202-00000