cL-7
CLUTCH - CLUTCH PEDAL
P u s h R o d P l a y
A d j u s t P o i n t
Push Bod
Play '\, \,
P e d a l H e i g h t
Adjust Point
P e d a l H e i g h t
P u s h R o d P l a Y
C L U T C H P E D A L
C L U T C H P E D A L C H E C K A N D
A D J U S T M E N T
1 . C H E C K T H A T P E D A L H E I G H T I S C O R R E C T
Pedal hoight from asphalt shoat:
L H D 1 4 4 . 9 - 1 5 4 . 9 m m ( 5 . 7 0 5 - 6 . 0 9 8 i n . )
R H D 1 4 1 . o - 1 5 1 . 0 m m ( 5 . 5 5 1 - 5 . 9 4 5 i n . )
* f f i t " '
2.
IF NECESSARY,
ADJUST PEDAL HEIGHT
Loosen the lock nut and turn th€ stopper bolt until the
height is corroct. Tighten the lock nut.
3.
CHECK THAT PEDAL FREEPLAY AND PUSH ROD
PLAY ARE CORRECT
Padal freeplay:
P u s h i n o n t h e p e d a l u n t i l t h s b e g i n n i n g o f c l u t c h
rosistanc€ is felt.
Pedal freeplay:
5 . 0 - 1 5 . 0 m m ( 0 . 1 9 7 - 0 . 5 9 1 i n . )
Purh rod play:
P u s h i n o n t h € p s d a l w i t h a f i n g e r s o f t l y u n t i l t h e
r o s i s t a n c o b e g i n s t o i n c r o a s e a l i t t l e .
Purh rod play tt Pedal top:
1 . 0 - 5 . 0 m m ( 0 . 0 3 9 - 0 ' 1 9 7 i n . )
4,
IF NECESSARY, ADJUST PEDAL FREEPLAY AND
PUSH ROD PLAY
(a) Loosen the lock nut and turn the push rod until tho
freeplay and push rod play are correct
(b) Tighten tho lock nut.
(c) After adjusting the pedal freeplay, check the pedal
height.
(d) Connect the air duct and install lhe lower finish panel.
5.
CHECK CLUTCH RELEASE POINT
(a) Pull the parking brake lever and install wheel stopper.
(b) Start the engine and idle tho ongin€.
(c) Without depressing the clutch pedal, slowly shift the
shift lever into reverse position until th€ goars con-
ta ct.