NEC Univerge SV8100 Features And Specifications Manual page 195

UNIVERGE SV8100
Trunk-to-Trunk Forwarding – Normal (0) Trunks
Program
Program Name
Number
11-10-06 Service Code Setup (for System
Administrator) – Setting the
Automatic Transfer for each
Trunk Line
11-10-07 Service Code Setup (for System
Administrator) – Canceling the
Automatic Transfer for each
Trunk Line
11-10-08 Service Code Setup (for System
Administrator) – Setting the
Destination for Automatic Trunk
Transfer
13-01-01 Speed Dialing Option Setup –
Speed Dialing Auto Outgoing
Call Mode
13-04-01 Speed Dialing Number and Name
– Speed Dialing Data
14-01-26 Basic Trunk Data Setup –
Automatic Trunk-to-Trunk
Transfer Mode
20-06-01 Class of Service for Extensions
20-07-05 Class of Service Options
(Administrator Level) – Set/
Cancel Automatic Trunk-to-
Trunk Transfer
SV8100 Features and Specifications Manual
Description/Comments
Customize the service code to be
used to set the Automatic Trunk
Forwarding feature.
Customize the service code to be
used to cancel the Automatic Trunk
Forwarding feature.
Customize the service code to be
used to set the destination for the
Automatic Trunk Forwarding
feature.
Determine if dialing an Speed
Dialing number will dial an outside
number (seizing a trunk as
assigned in Program 13-05) or an
Intercom number (0 = Trunk Dialing
Mode, 1 = Extension Dialing Mode).
Enter the Common and Group
Speed Dialing numbers and names
which are to be used for Trunk-to-
Trunk Forwarding.
Enable or Disable each trunk the
ability to use Step Transfer.
Assign a Class of Service (1~15) to
extensions.
Turns On (1) or Off (0) the ability of
an extension to use the
Trunk-to-Trunk Forwarding service
codes.
Assigned Data
1
MLT
(default = 733)
MLT
(default = 734)
MLT
(default = 735)
0 = Trunk Outgoing
Mode
1 = Intercom Outgoing
Mode
(default = 0)
#
1~9, 0, ,
Pause (Press line key
1)
Recall/Flash (Press
line key 2)
@ = Code to wait for
answer supervision in
ISDN (Press line key 3)
(maximum 24 digits)
(default not assigned)
0 = Normal Transfer
(Normal)
1 = Step Transfer
(Step)
(default = 0)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
0 = Off
1 = On
(default = 0 for
COS 1~15)
Issue 1.0
Level
2 3
2 - 171