Acura Integra 1998 Service Manual page 185

O i l Pu mp
Check the housing-to-outer rotor radial cleatance.
Housing-to-Outer Rotor Radial Clearance:
S t a n d a l d ( N e w ) : O . 1 0 - O . 1 9 m m
{ 0 . O 0 4 - O . O 0 7 i n )
Service Limit:
0.2O mm (O.OO8 inl
Inspect both rotors and pump housing tor scoring or
other damage. Replace parts if necessary.
Remove the old oil seal from the oil pump.
Gently tap in the new oil seal until the special tool
bottoms on the pump.
NOTE: The oil seal alone can be replaced without
removing the oil pump.
alllnspection/lnstallation (cont'd)
1 4 .
1 5 .
t o .
O I L P U M P
8-12
2 4
L
1 7 .
' 1 8 .
1 9 .
20.
Reassemble the oil pump, applying thread lock to the
pump housing screws.
Check that the oil pump turns freely.
Apply a light coat of oil to the seal lip.
Install the two dowel pins and new O-ring on the oil
p u m p .
Apply liquid gasket to the cylinder block mating sur-
face ol the oil pump.
N O T E :
. Use liquid gasket, Part No, 08718 - 0001 or 08718
- 0003.
a Check that the mating surlaces are clean and dry
betore applying liquid gasket.
a Apply liquid gasket evenly, in a narrow bead cen
tered on the mating surface.
a To prevent leakage of oil, apply liquid gasket to
the inner threads of the bolt holes.
a Do not installthe parts il 5 minutes or more have
elapsed since applying liquid gasket. Instead,
reapply liquid gasket atter removing the old
r e s r d u e .
a After assembly, wait at least 30 minutes before
f i l l i n g t h e e n g i n e w i t h o i l .
Install the oil pump on the cylinder block.
a Apply grease to the lip of the oil pump seal.
Then, install the oil pump onto the crankshaft.
W h e n t h e p u m p i s i n p l a c e , c l e a n a n y e x c e s s
grease oll the cranksfft-hd-chqck that the oil
seal lip is not disl6rted.
".\
l n s t a l l t h e o a l s c r e e n .
I n s t a l l t h e o i l p a n ( s e e p a g e 7 2 8 ) .
2 2 .
2 3 .