Table of Contents
Advertisement
Oil Filter
Replacement (cont'd)
Install the oil filter by hand.
A f t e r t h e r u b b e r s e a l s e a t s , t i g h t e n t h e o i l
clockwise with the special tool.
Tighten: 7/8 turn clockwise.
Tightening torque:22 N m (2.2 kgf m,'16 lbf ftl
t i l t e r
OIL FILTER WRENCH
8-8
Eight numbers (1 to 8) are printed on the surlace ol
the filter.
The lollowing explains the procedure for tightening
filters using these numbers.
1 ) M a k e a m a r k o n t h e e n g i n e o i l c o o l e r ( 8 1 8 c 5
e n g i n e ) o r c y l i n d e r b l o c k ( 8 1 8 8 ' 1 , 8 1 8 C 1 e n g i n e s )
under the number that shows at the bottom of
the filter when the rubber seal is seated.
2) Tighten the filter by turning it clockwise seven
numbers Irom the marked point. For example, if a
m a r k i s m a d e u n d e r t h e n u m b e r 2 w h e n t h e r u b
ber seal is seated, the filter should be tightened
until the number 1 comes up to the marked point
818C5 engine:
B1881, 818C1 engines:
Number when rubber
seal is seated.
N u m b e r a f t e r t i g h t e n i n g
MARK
MARK
N u m b e r w h e n r u b b e r
seal is seated
'I
2
3
4 5 6
7
8
Number after tightening
8
1
2
5 6 1
5.
After installation, fill the engine with oil up to the
specilied level, run the engine for more than 3 min-
utes, then check for oil leakage and oil level.
CAUTION: Installation using other than the above
procedure could result in serious engine damage
duo to oil leakage.
Advertisement
Table of Contents
Troubleshooting
