Table of Contents
Advertisement
O il Se a l
Installation
The seal surface on the block should be dry.
Apply a light coat of oil to the crankshaft and
t h e l i p o f t h e s e a l .
1 . D r i v e i n t l y w h e e l e n d s e a l a g a i n s t r i g h t s i d e c o v e r .
N O T E : D r i v e t h e e n d s e a l i n s q u a r e l y .
DRIVER
07749 - 0010000
C o n f i r m t h a t c l e a r a n c e i s e q u a l a l l t h e w a y a r o u n d
with a feeler gaug€.
Clearance: 0.5 - 0.8 mm {0.02 - 0.03 inl
RIGHT SIDE
COVER
lnstallation (engine removal not
requiredl
The seal surface on the block should be dry.
Apply a light coat of grease to the crankshaft and
to the lip of seal.
1 . U s i n g t h e s p e c i a l t o o l , d r i v e i n t h e t i m i n g p u l l e y -
e n d s e a l u n t i l t h e d r i v e r b o t t o m s a g a i n s t t h e o i l
p u m p .
When the seal is in place, clean any excess grease
o f f t h e c r a n k s h a l t a n d c h e c k t h a t t h e o i l s e a l l i p i s
not distoned.
SEAL DRIVER
07LAD. PR4O1OA
lnstall seal with the
p a n n u m b e r
facing out.
U s i n g t h e s p e c i a l t o o l , d r i v e i n t h e f l y w h e e l e n d s e a l
u n t i l t h e d r i v e r b o t t o m s a q a i n s t b l o c k .
NOTE: Align the hole in the driver attachment with
the pin on the crankshaft.
DRIVER
077{9 - 0010000
DRIVER ATT
07948 - 5800101
l n s t a l l s e a l w i t h t h e
n u m b e r s i d e f a c i n q
o u ! .
' t v A
,)/
\)
DBIVER ATTACHMENT
07948 - 5800101
Install sealwith the
pan number side
facang out.
[7
Fd
N O T E : R e f e r t o r i g h t c o l u m n a n d 8 - 1 1
t i o n o f t h e o i l p u m p s i d e o i l s e a l .
f o r i n s t a l l a -
Advertisement
Table of Contents
Troubleshooting
