Table of Contents
Advertisement
3 .
Removal/lnspection/lnstallation
Drain the engine oil.
Turn the crankshatt and align the white groove on
the crankshatt pulley with the pointer on the lower
cover.
Remove the cylinder head cover and middle cover.
Remove the power steering pump belt, air condition-
er belt and the alternator belt.
Remove the crankshaft pulley and remove the low-
er cover.
6.
Remove the timing belt,
7. Remove the drive pulley.
8.
Remove the oil pan and oil screen.
9.
Remove the oil pump.
OIL PUMP
OIL PAN
8 - 1
'10.
Remove the screws from the pump housing, then
separate the housing and cover.
1 1 . Check the inner-to outer rotor radial clearance on the
pumD rotor.
Inner Rotor-to-Outei Rotor Radial Clearance
S t a n d a r d ( N e w l : O . 0 4 - O . 1 6 m m
l O . O O 2 - O . O 0 6 i n t
Service Limir:
0.20 mm {0.O08 in)
12. Check the housing-to-rotor axial clearance
pump rotor.
Housing-to-Rotor Axial Clearance
Standard (New): 0.02-0.07 mm
( 0 . 0 O 1 - O . 0 0 3 i n )
Service Limit:
O.15 mm (0.006 inl
on tne
1
Advertisement
Table of Contents
Troubleshooting
