Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1072

Complete Software Guide for Junos
Configuration
CLI Quick
Configuration
Step-by-Step
Procedure
Verification
Purpose
Action
Meaning
968
®
OS for EX Series Ethernet Switches, Release 10.4
The topology for this example consists of four switches:
Two EX4200-24T switches
Two EX4200-48P switches
The switches are connected as a four-member Virtual Chassis configuration and are
identified as switch-A, switch-B, switch-C, and switch-D. The master is switch-A.
To assign the Virtual Chassis ID in a Virtual Chassis configuration:
To assign a Virtual Chassis ID so that when two Virtual Chassis configurations merge,
the ID that you assigned takes precedence over the automatically assigned Virtual Chassis
IDs and becomes the ID of the newly merged Virtual Chassis configuration, copy the
following command and paste it into the terminal window:
[edit]
set virtual-chassis id 9622.6ac8.5345
To assign the Virtual Chassis ID in a Virtual Chassis configuration:
Assign the Virtual Chassis ID:
1.
[edit]
user@switch-A# set virtual-chassis id 9622.6ac8.5345
NOTE: We recommend that you use the
to save any configuration changes that you make to a multimember
Virtual Chassis configuration.
To verify that the Virtual Chassis ID has been assigned as you intended, perform these
tasks:
Verifying That the Virtual Chassis ID Is Assigned on page 968
Verifying That the Virtual Chassis ID Is Assigned
Verify that the Virtual Chassis ID has been assigned in a Virtual Chassis configuration.
Issue the
1. show configuration virtual-chassis id
Check to see that the Virtual Chassis ID number is listed.
2.
user@switch-A> show configuration virtual-chassis id
id 9622.6ac8.5345;
The Virtual Chassis ID has been assigned as 9622.6ac8.5345.
commit synchronize
command.
Copyright © 2010, Juniper Networks, Inc.
command