Configure The Wi-Fi Radio's Band And Protocol - Digi TX54 User Manual

Hide thumbs Also See for TX54:

Table of Contents

3. Set the channel for the radio:

a. Determine available radios:

(config)> network wifi radio ?

Additional Configuration

---------------------------------------------------------------------

(config)> network wifi radio

b. Set the band for the appropriate radio to 5 GHz:

(config)> network wifi radio wifi1 band 5000mhz

c. Enable DFS client support :

(config)> network wifi radio wifi1 5000mhz dfs_client true

will not be started and cannot be used as access points.

4. Save the configuration and apply the change:

(config)> save

Configuration saved.

5. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Configure the Wi-Fi radio's band and protocol

For Wi-Fi radios that support both 2.4 GHz and 5 GHz modes, you can configure the band. .

On TX54 models with only one Wi-Fi radio, the default protocol and band for the one radio is

the 5 GHz ac.

On TX54 models with two Wi-Fi radios, Wi-Fi1 radio defaults to use 2.4 GHz b/g/n band, and

Wi-Fi2 radio defaults to use 5 GHz ac/n band.

TX54 User Guide

When DFS client support is enabled, any enabled access points that use this radio

Configure the Wi-Fi radio's band and protocol

Wi-Fi1 radio

Wi-Fi2 radio