Configure The Wi-Fi Radio's Band And Protocol - Digi Connect EZ 4 User Manual

Wi-Fi
3. Set the channel for the radio:
a. Set the band for the radio to 5 GHz:
(config)> network wifi radio phy0 band 5000mhz
(config)>
b. Enable DFS client support :
(config)> network wifi radio phy0 5000mhz dfs_client true
(config)>
Note When DFS client support is enabled, any enabled access points that use this radio
will not be started and cannot be used as access points.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure the Wi-Fi radio's band and protocol

For Wi-Fi radios that support both 2.4 GHz and 5 GHz modes, you can configure the band. .

WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > WiFi.
4. For Frequency band, select either 2.4 GHz or 5 GHz.
5. For Access point mode, select the appropriate mode. Only modes appropriate for the selected
band are displayed.
Digi Connect EZ 4/4i User Guide
Configure the Wi-Fi radio's band and protocol
221