Configure The Wi-Fi Radio's Band And Protocol - Digi LR54 User Manual

Wi-Fi
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the channel for the radio:
a. Determine available radios:
(config)> network wifi radio ?
Additional Configuration
---------------------------------------------------------------------
----------
wifi1
wifi2
(config)> network wifi radio
b. Set the band for the appropriate radio to 5 GHz:
(config)> network wifi radio wifi1 band 5000mhz
(config)>
c. Enable DFS client support :
(config)> network wifi radio wifi1 5000mhz dfs_client true
(config)>
Note
will not be started and cannot be used as access points.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure the Wi-Fi radio's band and protocol

For Wi-Fi radios that support both 2.4 GHz and 5 GHz modes, you can configure the band. Wi-Fi1
radio defaults to use 2.4 GHz b/g/n band, and Wi-Fi2 radio only supports 5 GHz ac/n.

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
LR54 User Guide
When DFS client support is enabled, any enabled access points that use this radio
Configure the Wi-Fi radio's band and protocol
Wi-Fi1 radio
Wi-Fi2 radio
265