Table of Contents
Advertisement
Wi-Fi
b. Enable DFS client support :
(config)> network wifi radio phy0 5000mhz dfs_client true
(config)>
Note
When DFS client support is enabled, any enabled access points that use this radio
will not be started and cannot be used as access points.
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the Wi-Fi radio's band and protocol
For Wi-Fi radios that support both 2.4 GHz and 5 GHz modes, you can configure the band. Wi-Fi radio
defaults to use 2.4 GHz b/g/n band
Note
Not all Digi devices currently support 5 GHz. Before you try to use this feature, verify that your
device supports 5 GHz.
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX20 User Guide
Configure the Wi-Fi radio's band and protocol
Use Digi Remote Manager to view and manage your
317
Advertisement
Table of Contents
