Default Outbound Wan/Wwan Ports - Digi TX54 User Manual

Hide thumbs Also See for TX54:

Table of Contents

5. Click Apply to save the configuration and apply the change.

Command line

1. Log into the TX54 command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Use the del command to delete the WAN or WWAN. For example, to delete a WWAN named

(config)> del network interface my_wwan

4. Save the configuration and apply the change:

(config)> save

Configuration saved.

5. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Default outbound WAN/WWAN ports

The following table lists the default outbound network communications for TX54 WAN/WWAN

Digi Remote Manager connection to my.devicecloud.com

NTP date/time sync to time.devicecloud.com

DNS resolution using WAN-provided DNS servers

HTTPS for modem firmware downloads from firmware.accns.com

TX54 User Guide

Wide Area Networks (WANs)